| Recall Date |
JUN 02, 1994 |
| Part Affected |
SUSPENSION:FRONT |
| Model Affected |
TRACER |
| Units Affected |
919
Get Details
|
Recall Date
JUN 02, 1994
Model Affected
1991 MERCURY TRACER
Recall Summary
THE OFFSET TOE ADJUSTING PIN CAN FRACTURE UNDER CONDITIONS SUCH AS TORSIONAL LOADS, FLEXING MOTION, IMPACT LOADS, AND OVERTORQUING.
Defect Consenquence
THIS CAN RESULT IN LOSS OF VEHICLE STEERING CONTROL ANDAN ACCIDENT.
Remedy
DANA WILL PAY FOR REPLACEMENT AND LABOR COSTS OF THE ADJUSTMENT PIN WITHOUT CHARGE TO THE INSTALLING FACILITY AND THE VEHICLE OWNER. THESE PINS SHOULD BE REPLACED BY A FORD ORIGINAL EQUIPMENT PIN ASSEMBLY. OWNER OR INSTALLER INQUIRIES CONCERNING THIS RECALL CAMPAIGN SHOULD CONTACT DANA SERVICE CENTER AT 1-800-248-9606.
Units Affected
919
Notes
DANA CORPORATION
| Recall Date |
AUG 19, 1992 |
| Part Affected |
FUEL SYSTEM, GASOLINE |
| Model Affected |
TRACER |
| Units Affected |
22000
Get Details
|
Recall Date
AUG 19, 1992
Model Affected
1991 MERCURY TRACER
Recall Summary
FATIGUE CRACKS CAN DEVELOP IN THE SOLDER JOINT BETWEEN THE FUEL RETURN TUBE AND THE FUEL PUMP SENDING UNIT LOCATED AT THE TOP OF THE FUEL TANK.
Defect Consenquence
SHOULD A CRACK DEVELOP, FUEL VAPOR CAN ESCAPE FROM THETANK WHEN THE TANK IS FULL, AND A SMALL AMOUNT OF FUEL CAN LEAK FROM THE CRACK.FUEL LEAKS CAN RESULT IN FIRE WHEN EXPOSED TO A SOURCE OF IGNITION.
Remedy
INSTALL A NEW FUEL PUMP SENDING ASSEMBLY.
Units Affected
22000
Notes
FORD MOTOR COMPANY
| Recall Date |
APR 15, 1993 |
| Part Affected |
ELECTRICAL SYSTEM:IGNITION:ANTI-THEFT CONTROLLER |
| Model Affected |
TRACER |
| Units Affected |
91000
Get Details
|
Recall Date
APR 15, 1993
Model Affected
1991 MERCURY TRACER
Recall Summary
THE ROLL PINS SECURING THE IGNITION LOCK IN THE STEERING COLUMN HOUSING CAN SEPARATE OR MOVE OUT OF POSITION.
Defect Consenquence
THE IGNITION LOCK CYLINDER MAY DISENGAGE FROM THESTEERING COLUMN HOUSING WHICH COULD CAUSE THE STEERING COLUMN TO LOCK UP,RESULTING IN LOSS OF VEHICLE CONTROL AND A POSSIBLE ACCIDENT.
Remedy
IF ONE OR BOTH OF THE ROLL PINS ARE MISSING OR NOT FULLY INSERTED, THE IGNITION LOCK HOUSING WILL BE REPLACED, ALONG WITH THE DOOR-LOCKS AND THE LIFTGATE OR DECK-LID LOCKS SO THAT KEY COMPATIBILITY IS MAINTAINED. IF BOTH PINS ARE PRESENT AND FULLY INSERTED, A PLASTIC SNAP-ON SLEEVE WILL BE INSTALLED AS A PRECAUTION TO PREVENT THE ROLL PINS FROM COMING OUT.
Units Affected
91000
Notes
FORD MOTOR COMPANY