Subscribe to the Free

Truck Trend Garage: 2000 Cadillac Escalade Bad Temperature Gauge

Alex Steele
Dec 1, 2009
Question: When I bought my 2000 Escalade (used), the temperature gauge did not work very well. The needle would fall well below the dial’s 100-degree mark, and only come up to about 150 or 160 when driving. I might add this is the only gauge in the cluster that is not working right. I’ve had the water temperature checked for fear that it was getting hot and I could not tell, but the temperature was fine, and I checked the thermostat housing ground. I changed the antifreeze, and after that I noted the gauge needle stopped at 100 and went up to about 190 or 200, but this only lasted for about one day and then it went back to below the 100-degree mark. What should I do next?
Answer: The actual gauge inside the instrument cluster could be causing the problem, but in this situation, the circuits have to be tested to find out for sure. There’s a special tool designed to do just that. General Motors’ service departments often use the Kent-Moore J33431 Signal Generator/Instrument Panel Tester. This tool can replicate signals such as vehicle speed, fuel level, and coolant temperature to aid in instrument panel diagnosis. Disconnect the coolant temperature sender connector, and connect special tool J33431 in its place. Then you can replace the signal from the sender with correct hot and cold signals from the tester. In this case you’re dealing with resistance (ohms), and the specifications are 1305 ohms “cold” (100 degrees) and 49.5 ohms “hot” (260 degrees). Once connected correctly, ignition on, adjust the tester resistance to 1305 ohms. The temperature gauge needle should be pointing right at 100 degrees. The same goes for the other end of the scale: With the tester at 49.5 ohms you should read 260 degrees on the gauge. If both readings are correct, that confirms the coolant temperature sender is defective; it’s sending out an inaccurate signal and needs to be replaced. Either that or the thermostat is stuck open and not raising coolant temperature. If the needle is pointing at the wrong temperature with the correct resistance applied, the problem lies upstream. Work your way toward the gauge with the tester. Remove the instrument cluster and apply the correct resistance directly to the coolant temperature gauge. If the needle is still pointing to the wrong temperature, the gauge is bad and will require replacement of the entire cluster. If the needle is now dead-on accurate, there’s a poor connection (high resistance) in the wiring between the sender and the gauge. The weak link can be in a number of areas, but the cluster connection itself is a common trouble spot.
How To Reach Alex
If you have a technical question regarding your pickup, SUV, or van, feel free to contact Alex, a master technician with the National Institute for Automotive Service Excellence. Send a letter to him in care of Truck Trend Garage, 831 S. Douglas Street, El Segundo, CA 90245, or e-mail us at Please include the VIN with your question. Due to the volume of questions received every month, we cannot guarantee that everyone's question will be personally answered or will appear in the magazine.

Can't wait for help with a problem you're having with your Truck or SUV? Ask the expert we trust here at Truck Trend Garage—visit Alex Steele at



Subscribe Today and Save up to 83%!

Subscribe Truck Trend Magazine

Subscribe to:

Truck Trend

Subscribe Diesel Power Magazine

Subscribe to:

Diesel Power

Subscribe Truckin Magazine

Subscribe to: